JVC VF-HP900G Instructions Manual page 11

Rear
A B C
.
A Power Switch
I[DC IN]: Receives power supply from the [DC IN]
0
terminal
○[OFF]: Switches off the power supply completely
0
Ⅱ[CAMERA]: Receives power supply from the VF
0
cable
B [SDI IN] Terminal
Input terminal for 3G/HD/SD SDI signals.
Memo :
Supports embedded audio signals.
0
C [SDI OUT] Terminal
Output terminal for 3G/HD/SD SDI signals.
Memo :
When power is turned on, signal from the [SDI IN] terminal
0
is passed through, and outputs the reclocked signal from
the [SDI OUT] terminal regardless of the state of the
[INPUT] button. On-screen display (OSD) is not output in
this case.
D [USB] Terminal
For connecting the USB device for loading the "3D-LUT"
file.
Memo :
Compatible USB device
USB specification: USB2.0
0
File system: FAT32
0
Maximum capacity supported: 16 GB
0
Before using, format the USB device with a FAT32 file
system.
E [HDMI] Input Terminal
Input terminal for HDCP-compatible HDMI signals.
F
D E
F [DC IN] Terminal (XLR type, 4-pin)
Input terminal for DC 12 V power supply (max. DC 17 V).
Memo :
J
If this unit is connected to a camera via a VF cable, there
0
is no need to supply power from the [DC IN] terminal.
I
H
G
.
G [VF CABLE] Terminal
To connect a VF cable, remove the rear cover.
(A P12 [Connecting the VF Cable] )
H Rear Cover
Be sure to use this unit with the rear cover attached.
I LARGE TALLY Lamp
The tally lamp lights up according to the settings of the
camera menu.
For GY-HC900 series, the tally lamp lights up
0
according to the [System]B[Front Tally] settings of
the camera menu.
Memo :
Brightness of the tally lamp can be configured in
0
[System]B[Large Tally].
(A P19 [ Large Tally ] )
J Speaker (Monaural)
Outputs mixed audio.
Memo :
When the [INPUT] button is set to "SDI" or "Camera",
0
audio configured in [Audio Ch] is output.
11
Introduction