Temperature Range; Temperature Display - Miele KWT 6722 iS Operating And Installation Instructions

Optimum temperature and air quality
When you touch the sensors, you will
see the following changes in the dis-
play:
– With the first touch:
The last temperature set flashes.
– Each subsequent touch:
The temperature changes in 1° incre-
ments.
– Keeping your finger on the sensor:
The temperature changes continu-
ously.
A negative tone will sound (if the sen-
sor tone is switched on) when the
lowest or highest possible tempera-
ture is reached.
Approximately 5 seconds after a sensor
has last been touched, the current
temperature inside the wine condition-
ing zone is shown automatically.
When the temperature is altered, there
is a short delay until the temperature
selected is set.
The temperature display in the control
panel always shows the actual tem-
perature.
30

Temperature range

In both zones, it is possible to set the
temperature between 41°F and 68°F
(5 °C and 20 °C).
A room temperature above 90°F
(32°C) may cause the temperature in
the lower section of the appliance to
increase slightly so that the tempera-
ture is approx. 2° above the tempera-
ture set for this section.
Wines which may not be stored un-
der these slightly raised temperature
conditions should preferably not be
placed on the 3D bottle presenter,
but instead should be placed on one
of the wooden shelves above it.

Temperature display

In normal operation, the temperature
display shows the actual temperature in
the zone.
If the temperature in one of the zones is
not within the range that the appliance
is able to display, dashes will light up in
the temperature display.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature in the display.