Messages in the display
Message
The alarm symbol is
lit up in the display and
both wine conditioning
zone sensors flash in
the control panel. An
audible alarm is also
sounding.
The alarm symbol is
flashing in the display,
and the sensor for one
of the wine conditioning
zones is also flashing.
An alarm also sounds.
The Change Active Air-
Clean filter symbol is
lit up.
A dash is lit up up/flash-
ing in the display.
"F0", "F1" or "E1" to "E8"
appears in the display.
Frequently Asked Questions
Possible cause and solution
The door alarm has been activated.
Close the wine unit door. Both wine conditioning
zone sensors and the alarm symbol will go out
and the acoustic alarm will stop.
The temperature in the zone concerned has risen
higher or fallen lower than the temperature set.
Possible reasons for this include:
– The appliance door was opened too frequently.
– The ventilation gaps have been blocked.
– A prolonged power failure has occurred.
Rectify the cause of the alarm. The alarm sym-
bol goes out and the sensor for the affected
wine conditioning zone lights up again constantly.
The alarm stops.
This is the reminder to change the Active AirClean fil-
ter.
Replace the Active AirClean filter and then confirm
the filter change in settings mode (see "Active Air-
Clean Filter").
Only temperatures within the range of the appliance
temperature will be displayed.
There is a fault.
Contact the Service department.
55