Braun cruZer body 5 Manual page 11

Plug the charger (8) into an electrical outlet. Place the cruZer body onto the
charger. The pilot light (7) indicates that the cruZer body is connected to an
electrical outlet.
Charging time is approximately 12 hours. Cordless operation time is up to
50 minutes.
Battery maintenance
In order to maintain the capacity of the rechargeable batteries, we recom-
mend that you unplug the charger and discharge the cruZer body by regular
use at least every 6 months.
How to use the cruZer body
Make sure that you always keep your skin stretched when shaving or
trimming.
The cruZer body is not intended for removing facial hair or scalp hair.
This appliance is suitable for use in a bath or shower.
• Trimming («1»):
Trimming on the skin / contour trimming
For trimming precise lines and contours, just use the trimmer (2)
(picture a).
Press the on/off switch (6) to turn on the cruZer body.
Stretching your skin, carefully move the trimmer against the direction of
hair growth.
For this function, you can use Gillette shaving foam or gel.
Using the trimming combs (1a) – (1c)
For best results use the trimming combs on dry hair only. Do not use
shaving foam or gel for this application. Whenever hairs build up in front
of the comb, remove them.
Trimming on the skin in sensitive areas (e.g. genital area) with the
«sensitive» attachment (1a)
For trimming in sensitive areas and improved skin care, you should use
the «sensitive» attachment (1a) (picture b). Snap it onto the trimmer (2)
as shown until it clicks into place. Press the on/off switch (6) to turn on.
Gently move the cruZer body against the direction of hair growth with
the comb tips pointing forward. In sensitive areas take special care that
the skin is always stretched to avoid injuries.
12