Mazda CX-30 2020 Owner's Manual page 544

Hide thumbs Also See for CX-30 2020:
Table of Contents

Advertisement

If Trouble Arises
Flat Tyre
If the tyre does not inflate, repair
of the tyre may not be possible. If
the tyre does not reach the
correct inflation pressure within a
10-minute period, it probably has
received more extensive damage.
When this happens, the
emergency flat tyre repair kit
cannot be used to repair the tyre.
Contact an expert repairer (we
recommend an Authorised
Mazda Repairer).
If the tyre has been over-inflated,
loosen the screw cap on the
compressor and bleed some of
the air out.
16.When the tyre has been inflated to
the proper inflation pressure, turn
the compressor switch off and
remove the compressor hose from
the tyre valve.
17.Install the tyre valve cap.
18.Put the emergency flat tyre repair
kit in the luggage compartment and
continue driving.
CAUTION
Drive carefully to an expert
repairer (we recommend an
Authorised Mazda Repairer) and
keep the vehicle speed below 80
km/h (50 mph).
If the vehicle is driven 80 km/h
(50 mph) or higher, the vehicle
might begin to vibrate.
NOTE
If the tyre is not properly inflated,
the tyre pressure monitoring system
warning light will illuminate (page
7-60).
19.After driving the vehicle for 10
minutes or 5 km (3 miles), check
the tyre pressure with the tyre
pressure gauge equipped with the
compressor. If the tyre pressure has
7-32
fallen below the correct tyre
pressure, inflate the tyre to the
correct pressure again following the
steps from number 14.
CAUTION
If the tyre inflation pressure falls
below 130 kPa (1.3 kgf/cm
bar, 18.9 psi), repair cannot be
done with the repair kit. Park the
vehicle on a level surface off the
right-of-way and contact an
expert repairer (we recommend
an Authorised Mazda Repairer).
If the tyre inflation pressure
continues to remain low after
repeating steps 13 to 20, park the
vehicle on a level surface off the
right-of-way and contact an
expert repairer (we recommend
an Authorised Mazda Repairer).
NOTE
When checking the tyre inflation
pressure with the tyre pressure
gauge on the compressor unit,
make sure the compressor switch is
turned off.
20.The emergency flat tyre repair is
completed if the tyre air pressure
does not decrease. Drive the
vehicle carefully to the nearest
expert repairer (we recommend an
Authorised Mazda Repairer)
promptly and have the tyre
replaced. Mazda recommends that
the tyre be replaced with a new
one. If the tyre is to be repaired and
reused, consult an expert repairer
(we recommend an Authorised
Mazda Repairer).
Peel off the speed restriction sticker
after replacing the tyre.
2
or

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents