Related Manuals for Satel micra MPD-300
Summary of Contents for Satel micra MPD-300
- Page 1 MPD-300 Wireless passive infrared detector Firmware version 2.00 mpd-300_en 06/20 SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gdańsk • POLAND tel. +48 58 320 94 00 www.satel.eu...
- Page 2 The rating plate of the device is located on the enclosure base. SATEL aims to continually improve the quality of its products, which may result in changes in their technical specifications and software. Current information about the changes being introduced is available on our website.
-
Page 3: Table Of Contents
CONTENTS Features ........................... 2 Description ........................2 Radio communication ....................... 2 Alarms ..........................2 Operating modes ......................2 Test mode ......................... 2 LED ..........................3 Supervision of motion detection system ................3 Battery status control ......................3 Electronics board ......................3 Selecting a mounting location ................... -
Page 4: Features
MPD-300 SATEL The MPD-300 detector detects motion in a protected area. The detector is supported by: PERFECTA alarm control panels (WRL models), VERSA-MCU controller, MTX-300 controller, MICRA alarm module (firmware version 2.02 or newer). This manual applies to the detector with firmware version 2.0. -
Page 5: Led
SATEL MPD-300 The LED is flashing for about 15 seconds from inserting the battery, signaling the warm-up of the detector. The LED is also enabled in the test mode, in which it indicates: periodical transmission – short flash (80 milliseconds), ... -
Page 6: Selecting A Mounting Location
MPD-300 SATEL jumper on – high sensitivity (Fig. 6). LED indicator. tamper switch activated by detector removal from the back tamper unit. tamper switch activated by cover removal. PIR sensor (dual element pyrosensor). scale for positioning of PIR sensor against the lens (Fig. 12). -
Page 7: Installation
SATEL MPD-300 Do not install the detector outdoors (A). Install the detector at the recommended height (B). When choosing the installation location, keep in mind that the detector performance will be the best where the expected direction of the intruder movement will be across the coverage pattern (C). - Page 8 MPD-300 SATEL for concrete, brick, etc. For other types of surface (drywall, styrofoam), use the appropriately selected wall plugs. If the detector is to be pet immune, do not mount it on the bracket. 10. Screw the enclosure base to the back tamper unit (Fig. 11).
-
Page 9: Specifications
SATEL MPD-300 5 Specifications Operating frequency band ............... 433.05 ÷ 434.79 MHz Radio communication range (in open area) PERFECTA ....................up to 600 m VERSA-MCU / MTX-300 / MICRA ............. up to 500 m MRU-300 ....................up to 400 m Battery ........................
Need help?
Do you have a question about the micra MPD-300 and is the answer not in the manual?
Questions and answers