Satel MGD-300 Quick Start Manual
  1. Manuals
  2. Brands
  3. Satel Manuals
  4. Security Sensors
  5. MGD-300
  6. Quick start manual

Satel MGD-300 Quick Start Manual

Wireless glass-break detector
Hide thumbs
1
2
3

Advertisement

Table of Contents

MGD-300
WIRELESS GLASS-BREAK DETECTOR
The MGD-300 detector enables detection of a break of plate, tempered and laminated glass.
It works with the MICRA alarm module (firmware version 3.00 or later) and VERSA-MCU
controller (firmware version 1.02 or later). This manual applies to the detector with electronics
version 1.2 or later.

1. Features

 Adjustable detection sensitivity.
 Advanced two-path sound analysis.
 LED indicator.
 Tamper protection in 2 ways – cover removal and tearing enclosure from the wall.

2. Electronics board

microphone.
potentiometer for adjustment of detection sensitivity (Fig. 3).
pins to enable/disable the test mode. In the test mode:
 the detector reports an alarm when it detects a high frequency
sound (glass break sound).
 the LED indicates alarms and periodic transmissions.
The test mode is enabled when the jumper is set as shown in
Fig. 2.
tamper contact.
CR123A battery. The detector checks the battery status. When the
voltage is lower than 2.6 V, the low-battery information is sent
during each transmission.
1471
mgd300_en 11/13

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MGD-300 and is the answer not in the manual?

Questions and answers

Related Manuals for Satel MGD-300

Summary of Contents for Satel MGD-300

  • Page 1 WIRELESS GLASS-BREAK DETECTOR mgd300_en 11/13 The MGD-300 detector enables detection of a break of plate, tempered and laminated glass. It works with the MICRA alarm module (firmware version 3.00 or later) and VERSA-MCU controller (firmware version 1.02 or later). This manual applies to the detector with electronics version 1.2 or later.
  • Page 2 MGD-300 SATEL 3. Operation description The detector will trigger an alarm when a low frequency sound (impact) followed by a high frequency sound (glass break) are registered in less than 4 seconds. The alarm is also triggered in the case of opening the tamper contact. Information on the alarm is sent by radio to the MICRA alarm module or VERSA-MCU controller.
  • Page 3 Enclosure dimensions..................25 x 111 x 28 mm Weight..........................40 g Hereby, SATEL sp. z o.o., declares that this detector is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. The declaration of conformity may be consulted at www.satel.eu/ce SATEL sp.

Table of Contents