Samsung NV10 Service Manual page 66

Ⅳ. ADJUSTMENT
② Set the camera on the Light source.
urn on the camera and the adjustment mode will be selected automatically.
③ Reset the camera.
④ The procedures will be started.
⑤ While the procedure is done, the camera checks the battery level. If the level is good, OK message will display
and the procedure keeps going. If the level is bad, NG message will display and the procedure stops.
- OK message : Blinking AF lamp one time (OK message will be printed by the Serial port)
- NG message : Blinking AF lamp two times (NG message will be printed by the Serial port)
⑥ After completing the procedure, data that was saved on the cash memory temporarily are moved to the
FlashRom of the camera.(To write the data, the procedure must be complete. Data saved on the FlashRom is
not affected by the F/W update)
66