Samsung NV10 Service Manual page 49

7. After completing the upgrade, the camera is turned off automatically.
8. Turn on the camera again and reset the camera by using the Reset menu.
4) Full Version of Firmware
▷Camera Status : When turning on the camera, the power consumption (Checking the POWER SUPPLY) is 200-
300mA and the camera can' be operated.
▷Cause : The data of "0" address in the FLASH MEMORY of the MAIN PCB is damaged.
▷Solution : Recover the address by doing the FULL VERSION FIRMWARE shown below.
▷Additions : After completing the upgrading of the FULL VERSION FIRMWARE, do the LENS SHADING and
CCD DEFECT CELL adjustment.
1. Short the 3 point of the MAIN PCB as shown.
49
Ⅳ. ADJUSTMENT