Samsung NV10 Service Manual page 62

Ⅳ. ADJUSTMENT
Set the camera on the Light source.
Turn on the camera and the adjustment mode will be selected automatically.
③ Reset the camera.
④ The procedures will be started.
⑤ While the procedure is done, the camera checks the battery level. If the level is good, OK message will display
and the procedure keeps going. If the level is bad, NG message will display and the procedure stops.
- OK message : Blinking AF lamp one time (OK message will be printed by the Serial port)
- NG message : Blinking AF lamp two times (NG message will be printed by the Serial port)
⑥ After completing the procedure, the data saved on the cash memory will be saved on the FlashRom. (If the
procedure is complete incorrectly, the file will not be written. Data saved on the FlashRom will not be deleted by
the Firmware upgrade)
62