Table of Contents
Advertisement
STEP
Adjust warm water temperature.
6
STEP
Testing shower function.
4
(1) Press the seat to enter sitting state (press force is
more than 12 N).
(2) Press Posterior button.
(3) Cover the front of nozzle with left hand after noz-
zle is extended to block water fl ow.
If this is your fi rst time to use the product, it will take
1 - 2 minutes to inject water to warm water tank.
Water cannot be heated to set temperature immedi-
ately, and warm water may spray out after about 5
minutes.
(4) Press STOP button or move your right hand from
the seat sensor zone to stop shower.
Please read the operation method, and confi rm other
functions.
Seat sensor is available to sense if there is anyone sitting on the
toilet seat. When press force is more than 12 N, shower, bidet,
deodorization or dryer function will work.
STEP
Adjust seat temperature.
5
(1) Press Seat Temp. button to adjust seat temperature.
(2) The indicator will be switched each time the button
is pressed, achieving appropriate temperature.
- Seat temperature takes 15 minutes to reach selected heat
when heating function is selected.
- Each time the button is pressed, the indicator will be
switched between "Off (indicator not turn on)", "Low", "Mid",
and "High" state.
- Initial setting is "Mid" when you first time using.
(1) Press Water Temp. button to adjust water temperature.
(2) The indicator will be switched each time the button is
pressed, achieving appropriate temperature.
Wash water temperature cannot be immediately heated to
warm state, it takes 10-15 minutes to reach desired heat.
Each time the button is pressed, the indicator will be switched be-
tween "Off (indicator not turn on)", "Low", "Mid", and "High" state.
Initial setting is "Mid" when you first time using.
17
Advertisement
Table of Contents
