Use Of Pump - Polygroup SUMMER WAVES ST1100 Owner's Manual

Before using the Pump
IMPORTANT:
1. Make sure to press the pump power switch to OFF before plugging the GFCI Power Cord Set
2. Always PRESS DOWN the 6-Port Valve Handle
3. Always BACKWASH the sand before filtering. This prevents fine sand from going through the pump and then to the pool, meanwhile washes off the dirt and debris
of the sand.
4. Make sure that the Hoses
r t
5. Fill the pool with water up to the FILL LINE. Do NOT dry run the filter pump.
6. FILTER PUMP ALONE WILL NOT PREVENT ALGAE FROM GROWING IN POOL WATER; THIS CAN ONLY BE DONE BY MAINTAINING PROPER CHLORINE
AND pH LEVELS AT ALL TIMES. For details, see POOL WATER CARE (p. 16).
POWER SWITCH
FUNCTIONS OF 6-PORT VALVE
Valve Handle Position
Reverses the water flow to wash the sand
Also prevents fine sand from ending up in your pool
ALWAYS remove the Blue Drain Outlet Cap
1 BACKWASH
and replace the cap when done.
* Backwash the sand when the pressure reading is 1-1.5 bar (14.5-21.8
Continue to backwash until the water from the drain outlet runs clean.
Levels out the sand bed after backwashing
ALWAYS remove the Blue Drain Outlet Cap
2 RINSE
and replace the cap when done.
Continue to rinse until the water from the drain outlet runs clean.
3 FILTER Normal filtration and vacuuming of the pool
Vacuums water directly to drain and lowers the pool water level
ALWAYS remove the Blue Drain Outlet Cap
WASTE
and replace the cap when done.
RECIRCULATE Recirculates water without filtering
CLOSED
Shuts off the water flow between the sand filter system and the pool
DO NOT SWITCH
DO NOT SWITCH ON THE PUMP
ON THE PUMP
For winterizing and storage
NULL
14

USE OF PUMP

BEFORE switching handle positions.
a
are firmly secured to the fittings on the pump and the pool.
Pool Inlet
Pool Outlet
Function
psi) ABOVE the initial pressure OR at least once every 2 weeks.
into a power outlet. Do NOT connect the Set to a timer device.
4
IMPORTANT: Do NOT
connect to a timer device!
before using this setting,
w
before using this setting,
w
before using this setting,
w
How to use the GFCI plug
Press
"RESET"
Button
To Start
Pump
Operation
4
*Do not connect
to a timer device
Water Flow Direction
Pool → Pump → Sand (Backward)
→ Drain Outlet
Pool → Pump → Sand (Forward)
→ Drain Outlet
Pool → Pump → Sand (Forward)
→ Pool
Pool → Pump → Drain Outlet
Pool → Pump → Pool
No water flow
DO NOT SWITCH ON THE PUMP
Excess water flow