Trunk Features; Ds1 Circuit Pack - Avaya IP 600 Configuration Note

Add DS1 Circuit Pack
Note: This is an E-1 so the
"Interface Companding"
must be set to alaw.
(normally as a T-1 it would
be set as mulaw).
UCC / Avaya one-X Speech - Avaya IP 600 / G3 / S8700 / S8300 E1 QSIG
display trunk-group 10

TRUNK FEATURES

ACA Assignment? n
Internal Alert? n
Data Restriction? n
Send Name: n
Used for DCS? n
Suppress # Outpulsing? n Numbering Format: public
Outgoing Channel ID Encoding: preferred
Send UCID? n
Send Codeset 6/7 LAI IE? y
Path Replacement with Retention? n
Path Replacement Method: better-route
Network (Japan) Needs Connect Before Disconnect? n
display ds1 2d13

DS1 CIRCUIT PACK

Location: 02D13
Bit Rate: 2.048
Signaling Mode: isdn-pri
Connect: pbx
CentreVu Long Timers? n
Interworking Message: PROGress
Interface Companding: alaw
Idle Code: 11111111
Slip Detection? n
Echo Cancellation? n
The above information is provided by AVAYA Inc. as a guideline. See disclaimer on page 1
Page 2 of 22
Measured: none
Maintenance Tests? y
NCA-TSC Trunk Member:
Send Calling Number: y
Hop Dgt? n
UUI IE Treatment: service-provider
Replace Restricted Numbers? n
Replace Unavailable Numbers? n
Send Called/Busy/Connected Number: y
Ds1 Echo Cancellation? n
Page 1 of 2
Name: E1 QIG
Line Coding: hdb3
Interface: peer-master
Peer Protocol: Q-SIG
CRC? y
Channel Numbering: timeslot
DCP/Analog Bearer Capability: 3.1kHz
Near-end CSU Type: other
C o n f i d e n t i a l
Wideband Support? n
Side: a
9