Feig Electronic PAN MOBILE ID smartSCANNDY User Manual page 18

IDENTIFICATION
8 Wi-Fi Connection
WiFi Connection
To connect Wi-Fi enabled devices to a host.
1. Connect the device to the host using the USB port and use the Master Setup to set the data output mode
to Wi-Fi.
2. Open the file "config.ini" setup the parameters for Wi-Fi and host connection (See the document
"Config_ini" section Wi-Fi to learn how to set the parameters for Wi-Fi communication).
3. Save the settings and disconnect the device from the computer.
4. The device tries to connect to the configured wireless network. The blue LED (2) flashes every second. If
the device could connect to the wireless network and to the host, the blue LED (2) flashes slowly every 3
seconds.
If the device fails to connect, please check the parameters configured in the file "config.ini". Ask your network
administrator for assistance if necessary.
ID smartSCANNDY 8 WiFi Connection
Page 18 of 24