Table of Contents
Advertisement
IDENTIFICATION
6.4.2 1D/2D Imager
To scan a barcode follow the steps below:
1. Aim the scanner at the barcode.
2. Press the trigger key (3).
3. The ID smartSCANNDY decodes the barcode closest to the cross center unless you disable the Pick-
List Mode (see below) in the 2D cameras.
4. The device beeps and the right LED (2) lights up green to indicate a successful decode.
Disabling the Pick-List Mode automatically:
1.
Please download "config.ini" from www.panmobil.com.
2.
Copy the new file to the device and replace the existing.
3.
Restart the device. Afterwards the Pick-List Mode is turned off.
Disabling the Pick-List Mode manually:
1.
Connect the device to your computer.
2.
Open the drive "SCANNDY".
3.
Open "config.ini" on the drive.
4.
Set Pick-List Mode=0
5.
Save the changes.
6.
Disconnect the device from your computer.
7.
Restart the device. Afterwards the Pick-List Mode is turned off.
ID smartSCANNDY
Fig. 6: Scan Example 1D/2D Imager
6 Operation
Page 14 of 24
Advertisement
Table of Contents
