Download Print this page

Pentair Flotec FP5200 Series Installation And Operation Manual

Self-priming centrifugal pump

Advertisement

FP5200 SERIES SELF-PRIMING
CENTRIFUGAL PUMP
INSTALLATION AND
OPERATION MANUAL
pentair.com
FLOTECH

Advertisement

loading

Summary of Contents for Pentair Flotec FP5200 Series

  • Page 1 FLOTECH FP5200 SERIES SELF-PRIMING CENTRIFUGAL PUMP INSTALLATION AND OPERATION MANUAL pentair.com...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS: SECTION ........................................PAGE Safety Infomation.....................................3 Installation....................................4-5 Electrical Installation..................................6 Operations....................................... 7 Maintenance....................................8-9 Repair Parts....................................10-11 Troubleshooting....................................12 Warrenty......................................13...
  • Page 3: Safety Infomation

    SAFETY INFORMATION Carefully read and follow all safety instructions in this manual GENERAL SAFETY or on pump.Keep safety labels in good condition. Replace missing or damaged safety labels. This is the safety alert symbol. When you see this symbol on Hazardous pressure! Install pressure relief your pump or in this manual, look for one of the following signal valve in discharge pipe.
  • Page 4: Installation

    INSTALLATION PRIOR TO PUMP INSTALLATION HORIZONTAL PIPING FROM WELL TO PUMP INSTALLATION • The well must not be more than 20 foot depth to water. Never install a suction pipe that is smaller than the suction • Long runs and many fittings increase friction and reduce port of the pump.
  • Page 5 INSTALLATION LAWN SPRINKLING APPLICATION This pump is designed for a pond, cistern or well points. Pump 1 0 0 discharge can be divided to supply two (2) or more sprinkler systems. A suggested multiple dis charge to service is shown in Figure 3.
  • Page 6: Electrical Installation

    ELECTRICAL INSTALLATION WIRING Install, ground, wire and maintain this pump in accordance with electrical code requirements. Consult your local building inspector for information about codes. Read and follow all warnings below. Power Lead Terminals WARNING Hazardous voltage. Can shock, burn, or cause L1 and L2 death.
  • Page 7: Operations

    OPERATIONS PRIMING THE PUMP Priming refers to the pump expelling all air in the system and beginning to move water from its source out into the system. It does not refer only to pouring water into the pump (although pouring water in is usually the first step). Make sure suction and discharge valves and any hoses on discharge side of pump are open.
  • Page 8: Maintenance

    MAINTENANCE The pump and piping do not need to be disconnected to repair or replace the motor or seal. If motor is replaced, a new shaft seal must be installed. Keep an extra shaft seal on hand for future needs. Check motor label for lubrication instructions.
  • Page 9 MAINTENANCE NOTICE: Be sure not to nick or scratch carbon face of seal Remove rotating half of seal by placing two screw drivers under seal ring and carefully prying up (Figure 17). when passing it over threaded shaft end or shaft shoulder. Remove nuts from studs holding seal plate to motor.
  • Page 10: Repair Parts

    REPAIR PARTS 2419A 0605 FP30 (11-21-19)
  • Page 11 REPAIR PARTS Model Number FP5242-00 FP5252-00 Part Description 1-1/2 HP 2 HP Motor, 115/230V, 1 Phase J218-601PKG — Motor, 115/230V, 1 Phase — J218-883APKG Water Slinger 17351-0009 17351-0009 Seal Plate C3-155 C3-117 Gasket - Seal Plate C20-86 C20-87 O-Ring 25276 34516 Shaft Seal U109-6B...
  • Page 12: Troubleshooting

    TROUBLESHOOTING CHART Symptom Possible Cause(S) Corrective Action Disconnect switch is off Be sure switch is on Fuse is blown Replace fuse Starting switch is defective Replace starting switch Refer to instructions on wiring. Check and tighten all wiring. Motor will not run WARNING Capacitor voltage may be hazardous.
  • Page 13: Warrenty

    WARRANTY This Limited Warranty is effective June 1, 2011 and replaces all undated warranties and warranties dated before June 1, 2011. FLOTEC warrants to the original consumer purchaser (“Purchaser” or “You”) that its products are free from defects in material and workmanship for a period of twelve (12) months from the date of the original consumer purchase.
  • Page 14 293 WRIGHT STREET | DELAVAN, WI 53115 | PH: 866-973-6835 | ORDERS FAX: 800.321.8793 | PENTAIR.COM *For a detailed list of where Pentair trademarks are registered, please visit www.pentair.com/en/registrations.html. Pentair trademarks and logos are owned by Pentair plc. or its affiliates. Third party registered and unregistered trademarks and logos are the property of their respective owners. Because we are continuously improving our products and services, Pentair reserves the right to change specifications without prior notice.

This manual is also suitable for:

Fp5242Fp5252