Preparing Kombitool For Operation; Assembling The Kombitool; Connecting Drive Tube To Gear Housing; Mounting And Removing The Kombitool - Stihl RG-KM Instruction Manual

English

5 Preparing KombiTool for Operation

5.1 Preparing KombiTool for Operation
Perform the following steps before starting work:
► Make sure the following components are in a safe
condition:
– KombiTool, @ 4.6.1.
– KombiMotor, as described in the instruction manual.
► Clean the KombiTool, @ 12.1.
► Connect drive tube to the gearbox, @ 6.1.
► Mount the KombiTool on the KombiMotor, @ 6.2.1.
► If you are using a KombiMotor with a loop handle: Mount
a barrier bar as described in the KombiMotor's instruction
manual.
► Use a carrying system, @ 8.1.
► If you cannot carry out the above steps: Do not use the
KombiTool and contact your STIHL servicing dealer for
assistance.

6 Assembling the KombiTool

6.1

Connecting Drive Tube to Gear Housing

1 3
2
2
1
► Remove protective caps (1) from both ends of the drive
tube (2).
8
5
4
6
5 Preparing KombiTool for Operation
► Loosen the screw (6).
► Push the drive tube (2) into the gear housing (5) and rotate
it until the gear shaft (4) engages.
► Tighten the screw (6) moderately.
► Align the drive tube (2) so that the lug (3) faces up.
► Tighten down the screw (6) firmly.
The drive tube need not be removed again.
6.2

Mounting and Removing the KombiTool

6.2.1 Mounting the KombiTool
2
3
4
1
► Loosen the wing screw (1).
► Line up the lug (4) and the slot (3).
► Push the drive tube (5) into the coupling sleeve (2) as far
as stop.
The red line (6) is flush with the coupling sleeve (2).
► Tighten down the wing screw (1) firmly.
6.2.2 Removing the KombiTool
► Fit the transport guard.
► Loosen the wing screw on the KombiTool.
► Pull the drive tube out of the KombiTool.
2
6
5
1
0458-811-0121-A