Cleaning The Blades; Maintenance; Maintenance Intervals; Lubricating The Gearbox - Stihl RG-KM Instruction Manual

13 Maintenance

► Clean the KombiTool with a damp cloth.

12.2 Cleaning the Blades

► Switch off the KombiMotor.
► Spray the blades with STIHL resin solvent.
► Switch on the KombiMotor for 5 seconds.
The blades run. STIHL resin solvent is distributed evenly.
13 Maintenance

13.1 Maintenance Intervals

The maintenance intervals are dependent on the
environmental and operating conditions. STIHL
recommends the following maintenance intervals:
After every 25 hours of operation
► Lubricate the gearbox.

13.2 Lubricating the Gearbox

► Switch off the KombiMotor.
1
► Remove the screw plug (2).
► If no grease can be seen on the end of the screw plug (2):
► Screw the tube (1) of STIHL gear grease into the filler
hole.
► Pump 10 g of STIHL gear grease into the gear housing.
► Unscrew the tube (1) of STIHL gear grease.
0458-811-0121-A

13.3 Removing and Attaching the Blade

13.3.1 Removing the Blades
The cutting edges of the blades are sharp. There is a risk of
cut injuries.
► Wear work gloves made of durable material.
► Switch off the KombiMotor.
► Remove screw (1) clockwise.
2
► Remove the rider plate (2).
► Remove screws (3) counterclockwise.
► Remove the blade (4).
► Remove screws (5) counterclockwise.
► Remove the blade (6).
13.3.2 Mounting the Blades
The cutting edges of the blades are sharp. There is a risk of
cut injuries.
► Wear work gloves made of durable material.
► Refit and tighten down the screw plug (2) firmly.
► Run the KombiMotor for 1 minute.
STIHL gear grease is distributed evenly.
WARNING
1
2
3
4
WARNING
English
5
6
11