ELGO-PLUS SpringerMAX Instructions Manual page 26

All points where parts are in move must be properly lubricated. Below there is exepmplary
lubrication point, All these points are equipped with grease nipples.
It is required to lubricate every time before working.
A Grease nipple
6.5. Hydraulic pressure control
Warning:
Working pressure of the hydraulic system is factory-set to 160 atm. Regulatory made
only in justified cases. Changing the operating pressure is not recommended for
unexperienced users..
A Hydraulic pressure controler
6.6. Tracks tension regulation
A
PIC.6.4 POINT OF LUBRICATION
PIC.6.5 HYDRAULIC PRESSURE CONTROL
25
A