Table of Contents
Advertisement
RSP Redundancy
Table 5: Supported Interface Modules and Part Numbers for N560-RSP4 and N560-RSP4-E
RSP Module
N560-RSP4
and
N560-RSP4-E
RSP Redundancy
The Cisco ASR 907 Router chassis includes two RSP slots to allow for redundant RSPs. When the router uses
redundant RSPs, one RSP operates in the active mode and the other operates in the hot standby mode. Removal
or failure of the active RSP results in an automatic switchover to the standby RSP.
Note
If you are using redundant RSPs, both the RSPs must be of the same type because a mixed configuration of
two different RSP types is not supported.
Network Timing Interfaces
The RSP supports the following network timing interfaces:
• BITS input/output port—RJ48 jack
• 1 PPS input and output—Mini coax connectors
• 2.048 or 10 MHz input and output—Mini coax connectors
• Time of Day (ToD) or 1 PPS input or output port—Shielded RJ45 jack
Cisco ASR 907 Router Hardware Installation Guide
12
Interface Modules
8-port Gigabit Ethernet SFP Interface
Module (8X1GE)
8-port Gigabit Ethernet RJ45
(Copper) Interface Module (8X1GE)
1-port 10 Gigabit Ethernet XFP
Interface Module (1X10GE)
SFP Combo IM—8-port Gigabit
Ethernet (8X1GE) + 1-port 10 Gigabit
Ethernet (1X10GE)
Copper Combo IM—8-port Gigabit
Ethernet (8X1GE) + 1-port 10 Gigabit
Ethernet Interface Module (1X10GE)
2-port 10 Gigabit Ethernet Interface
Module (2X10GE)
2x100G Interface module
8-port SFP/8-port CSFP Gigabit
Ethernet (8/16X1GE) + 1-port 10
Gigabit Ethernet (1X10GE) Interface
module
8x10G Interface module
Cisco ASR 907 Router Overview
Part Number
Slot
A900-IMA8S
Not Supported
A900-IMA8T
Not Supported
A900-IMA1X
Not Supported
ASR900-IMA8S1Z
Not Supported
ASR900-IMA8T1Z
Not Supported
ASR900-IMA2Z
Not Supported
N560-IMA2C
7,9
A900-IMA8CS1Z-M
0,1,2,3,4,5,6,7,8,9,10,11,12,13,14
and 15
A900-IMA8Z
4,5,7,9,10 and 11
Advertisement
Table of Contents
