Probe - TESTO 435 Series Instruction Manual

6.1.4 Probe

RadioC
Radio probes may only be used in countries in which they have been Type
Approved (see application information of the radio probe).
A radio module (accessory part) is required for the use of radio probes. The
instrument can establish a connection with a maximum of three radio probes.
Each radio probe has a probe ID (RF ID). This consists of the last 3 digits of the
serial no. and the position of the slide switch (H or L) in the radio probe.
Setting u u p a a r r adio p p robe:
A radio module (accessory part) is inserted in the instrument.
See chapter
The configuration menu is open, config. is displayed.
The radio probe is switched on and the transfer rate is set to 2 readings
per second (see the advice on using the radio probe).
Probe
1 OK
Press /
2
P.2 or P.3) and confirm with
- The instrument searches for switched-on radio probes in the receiving
range.
- The probe IDs of the radio probes found are displayed.
If no radio probes were found, this may be because of the following:
· The radio probe is not switched on or the battery of the radio probe is
spent.
· The radio probe is outside the range of the measuring instrument.
· Sources of interference are influencing the radio transmission (e.g.
reinforced concrete, metal objects, walls or other barriers between
transmitter and receiver, other transmitters of the same frequency,
strong electromagnetic fields).
If necessary, rectify the possible causes of the fault in radio
transmission.
Alternatively, the probe ID can also be entered manually.
Press
MAN
Press /
3
channel no.
Assign the radio probe to the chosen channel no. with
4
, p. 41.
C
OMMISSIONING
.
RadioC
OK
to select the desired channel no. for the radio probe (P.1,
.
OK
/ to enter the probe ID.
to select the probe that is to be assigned to the chosen
6. Setting the instrument 47
.
OK