Vehicle Disassembly - MB QUART MBQX-SUB-2 Installation Manual

VEHICLE DISASSEMBLY

Console side and lower center dash removal (steps 1-3) aren't necessary if you've already installed the
subwoofer wiring harness(es) per instructions from the Stage kit. Source unit requires removal.
REMOVE CONSOLE SIDES
1
Remove driver's side console
side panel using a pry tool from
the top to gently release the
pressure-fit clips.
REMOVE CENTER DASH HARDWARE/CLIPS AND SOURCE UNIT
4
Remove top center plastic
cover above dash pocket by
pushing up on the front pocket
edge above the lighter socket,
then pulling toward you.
7
Identify four visible push pin
clips on the outer edges of the
center pocket. These secure
the flanges of the left and right
side dash speaker panels.
2
Remove passenger's side
console side panel using a
pry tool from the top to gently
release the pressure-fit clips.
5
Next, remove two additional
T-30 screws located beneath
the forward edge of the top
center plastic cover location,
just forward of fuse box.
8
Gently remove the four visible
push pin clips with a panel
removal tool or special panel
clip pliers (not needle nose) as
shown.
4
3
Remove front of center console
side panel on passenger's side
(footwell area) using a pry tool
to gently release the pressure-
fit clips.
6
Remove four T-25 screws
securing the source unit
housing to the center of the
dash. Two in front, two in back
near master brake cylinder.
9
Remove one additional hidden
push pin under the driver's side
dash, between the steering
wheel and console, just forward
of the tubular chassis support.