Intended Use - DeWalt DCG414 Original Instructions Manual

EnGLIsh
Markings on Tool
The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Visible radiation. Do not stare into light.
Date Code Position (Fig. A)
The date code 21 , which also includes the year of manufacture,
is printed into the housing.
Example:
2018 XX XX
Year of Manufacture
Description (Fig. A, D, F)

WARNING: Never modify the power tool or any part of it.
Damage or personal injury could result.
Trigger switch
1
Lock-off lever
2
Spindle lock button
3
Spindle
4
Side handle
5
Abrasive wheel (Fig. F)
6
Backing flange
7
Threaded clamp nut
8
Guard
9
Guard release lever
10
Battery pack
11
Battery release button
12
Fuel gauge button
13
Screw
14
Lugs
15
Gear case slots
16

Intended Use

The DCG414 cordless angle grinder has been designed
for professional cutting, grinding, sanding and wire
brush applications.
DO nOT use under wet conditions or in the presence of
flammable liquids or gases.
This cordless angle grinder is a professional power tool.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
Young children and the infirm. This appliance is not
•
intended for use by young children or infirm persons
without supervision.
48
• This product is not intended for use by persons (including
children) suffering from diminished physical, sensory or
mental abilities; lack of experience, knowledge or skills
unless they are supervised by a person responsible for their
safety. Children should never be left alone with this product.
Electronic Clutch
The electronic torque limiting clutch reduces the maximum
torque reaction transmitted to the operator in case of jamming
of a disc. This feature also prevents the gearing and electric
motor from stalling. The torque limiting clutch has been factory-
set and cannot be adjusted.
Brake
Once the power is shut off, the brake stops the wheel spinning
more quickly than a unit without this feature. This improves
efficiency and increases user protection. Stopping time will vary
depending upon the type of wheel used.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect battery pack
before making any adjustments or removing/
installing attachments or accessories. An accidental
start-up can cause injury.

WARNING: Use only D
Attaching Side Handle (Fig. C)

WARNING: Before using the tool, check that the handle is
tightened securely.

WARNING: The side handle should always be used to
maintain control of the tool at all times.
Screw the side handle 5 tightly into one of the holes on either
side of the gear case.
To improve user comfort, the gear case will rotate 90° for
cutting operations.
Rotating the Gear Case (Fig. A)
1. Remove the four corner screws attaching the gear case to
motor housing.
2. Without separating the gear case from motor housing,
rotate the gear case head to desired position.
nOTE: If the gear case and motor housing become separated
by more than 3.17 mm, the tool must be serviced and
re-assembled by an authorised D
to have the tool serviced may cause motor and bearing failure.
3. Reinstall screws to attach the gear case to the motor
housing. Tighten screws to 2.25 N m torque. Overtightening
could cause screws to strip.
Guards

CAUTION: Guards must be used with all grinding
wheels, cutting wheels, sanding flap discs, wire
brushes, and wire wheels. The tool may be used
without a guard only when sanding with conventional
sanding discs. Refer to Figure A to see guards provided
with the unit. Some applications may require purchasing
WALT battery packs and chargers.
e
WALT service centre. Failure
e