Philips Sonicare Elite+ User Manual page 14

ENGLISH
14
4 Remove the end cap from the toothbrush handle. If the end cap
does not release easily from the housing, repeat step 3 until the
end cap is released (Fig. 13).
5 Holding the handle upside down, press the shaft down on a hard
surface. If the internal components do not easily release from the
housing, repeat step 3 until the internal components are released.
(Fig. 14)
6 Remove the inner assembly from the housing by fully inserting a
small flat-head screwdriver into the slot opposite the circuit board
and pry until it comes apart (Fig. 15).
7 Grab the battery and pull it out of the internal assembly (Fig. 16).
Be aware of the sharp edges of the battery tabs so as to avoid
injury to your fingers.
8 Cut the battery wires from the circuit board close to the battery
(Fig. 17).
9 Cover the battery contacts with tape to prevent any electrical short
from residual battery charge. The rechargeable battery can now be
recycled and the rest of the product discarded appropriately.
Guarantee and support
If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet.
Troubleshooting
This chapter summarises the most common problems you could encounter
with the appliance. If you are unable to solve the problem with the
information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.