Related Manuals for Lasertec LDM25
Summary of Contents for Lasertec LDM25
- Page 1 L D M 2 5 L A S E R D I S T A N C E M E A S U R E R I N S T R U C T I O N M A N U A L...
- Page 2 SAFETY Read the following safety instructions before attempting to operate this product. SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE. WARNING: Read ▪ Do not place the laser in a understand all instructions. position which cause ▪ anyone intentionally Use the laser measurer only with the specified batteries.
-
Page 3: Item Checklist
ITEM CHECKLIST Please ensure the following items are included with your laser distance measurer. If anything is missing please contact your retailer. Lasertec LDM25 Alkaline batteries... -
Page 4: Product Overview
PRODUCT OVERVIEW LASER MEASURER FRONT Laser emitter LCD screen Control panel... - Page 5 LASER MEASURER BACK Battery compartment...
- Page 6 CONTROL PANEL · Power on · Read: laser emission on · Power off (press and hold) · Clear...
-
Page 7: Display Screen
DISPLAY SCREEN Laser emission on Reference point Battery level Measurement display Continuous measurement mode Main measurement display Unit Length measurement mode Minimum and maximum values in continuous measurement mode... -
Page 8: Operation
USING YOUR LASER MEASURER POWER SUPPLY ▪ The instrument is supplied with two 1.5v AAA alkaline batteries. To replace batteries, remove the battery door at the back of the device. Place batteries according to polarity and replace battery door. ▪ For infrequent use, please take out the battery to avoid corrosion to the body of the device. - Page 9 MEASUREMENT Single measurement a) Press the read button. The laser will be emitted. b) Re-press the read button for a single distance measurement. Results will be displayed on the main measurement display. c) The previous two measurements will also be displayed above the main measurement display.
-
Page 10: Troubleshooting
TROUBLE SHOOTING Error code Cause & solution Signal is too weak. ERR1 Measure target locations that have stronger reflecting surfaces. Signal is too strong. ERR2 Measure target locations that have weaker reflecting surfaces. Battery voltage too low. ERR3 Replace batteries. Beyond working temperature. -
Page 11: Care And Maintenance
CARE AND MAINTENANCE ▪ Inaccurate measurement results may occur in harsh environments such as strong sunlight, excessive temperature fluctuations, weak / strong reflective surfaces or low battery power. ▪ Whenever possible, store the instrument in a cool, dry place. Do not store in high temperatures or strong humidity for long periods of time. -
Page 12: Warranty
WARRANTY The Lasertec LDM25 comes with a 3 year manufacturers warranty. AUSTRALIA "Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. -
Page 13: Specifications
SPECIFICATIONS Specifications Lasertec LDM25 Product code 91435 Accuracy ±2mm Minimum measurement range 0.05m Maximum measurement range Minimum unit displayed 0.001mm Measurement unit m (metres) Continuous measurement function Area measurement function Volume measurement function Add and subtract measurement function Automatic backlight... - Page 14 NOTES...
- Page 15 NOTES...
- Page 16 ww w.spo ton.c om.au...