Toshiba OIS PLUS Series User Manual page 65

Procedure to mount the unit:
Gasket
Mounting
Clamp
Figure - 1
Figure - 3
Make a cut-out of the required size. Panel cut-out tolerance is +0.00mm. Put the gasket behind the bezel.
The gasket may be sealed to the case using adhesive.
FIGURE - 1 There are four (4) slots provided on the unit case to mount the unit.
FIGURE - 2 A set of four (4) mounting hardware is provided with each OIS
PLUS3 unit.
(It is consist of single cap nut, screw and clamp)
FIGURE - 3 Insert the clamp into the slot provided on the unit case. hold the unit straight.
Tighten the mounting screws evenly to a torque between 0.5 and 0.6 Nm.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Mounting Hardw are is a set of cap nut, screw & clamp
Screw
C l a m p
Cap Nut
Mounting
Hardw are
Figure - 2
Figure - 4