Toshiba OIS PLUS Series User Manual page 90

9. When the value of high speed counter register reaches to value of preset register, then HSC Preset
Reached bit will be ON.
10. Download the program to the HMI and enter the values with keypad on the screen.
Related registers:
Function Register/device
Channel 1
X0
Count input
Reset input X1
Count Value MW0101
MW0102
Preset MW0103
MW0104
Soft gate MW0105_0
Reset Bit MW0105_1
Preset M01083
Reached Bit
Note1: When all four channels are used as HSC, IP1 to IP8 cannot be used as normal input devices. How-
ever, if either one channel is used, the inputs for unused channel can be used as normal input devices.
Note2: Two words are used for storing the double word (32bit) count/set values.
Lower word will contain Lower 16 bit value and Higher word will contain Higher 16 bit
This register storage scheme is applicable for all the modes.
value. Eg. Count value
So if count value is (Hex) 87654321
Note3: Input5, Input6, Input7 and input8 are used as reset inputs for count inputs 1, 2, 3 and 4. So do not use
Input5, Input6, Input7 and input8 as normal inputs when expansion module is configured in this mode.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Channel 2 Channel 3
X5 X2
X6 X3
MW0107 MW0113
MW0108 MW0114
MW0109 MW0115
MW0110 MW0116
MW0111_0 MW0117_0
MW0111_1 MW0117_1
M01179 M01275
: MW0101, MW0102
MW0101 = 4321 (Hex)
MW0102= 8765 (Hex)
Remarks
Channel 4
X7
Count Input channels
X4 Physical reset i/p channels
MW0119 Data range: H0000 0000 to
MW0120 HFFFF FFFF
MW0121 Set count value: Max.
MW0122 4294967295
MW0123_0 Operation is enabled when
bit ON
MW0123_1 Used to reset the counter
value
M01371 This bit turns on, when
counter reaches to preset
register value