HermanMiller Setu Table Installation

Hide thumbs Also See for Setu Table:

Parts Included:

Pan Head Tapping

Screw (4)

Hardware Pack

Power Driver

#2 Phillips Bit

® Y, Z, Action Office, and Mirra 2 are among the registered trademarks of Herman MIller, Inc.

Sense, Setu, Be Collection and Sayl are among the trademarks of Herman Miller, Inc.

Illustrations and specifications are based on the latest product information available at the time of publication.

The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products.

Table Top

Spider

7/8" Hex Socket

Anti-Rotation Cap

Torque Wrench

Setu

Table Installation

™

Base Assembly

Column

Lock Washer

Draw Rod

Part no. 1b9rtx rev C.

Table of Contents

Do you have a question about the Setu Table and is the answer not in the manual?

Page 1 Setu Table Installation ™ Parts Included: Base Assembly Table Top Spider Draw Rod Column Pan Head Tapping Screw (4) Anti-Rotation Cap Lock Washer Hardware Pack Tools Required: Power Driver 7/8” Hex Socket Torque Wrench #2 Phillips Bit Part no. 1b9rtx rev C. ©...
Page 2 Screw Board Spider Screw Screw Board Screw Notice: If Spider comes mounted to 2 boards, remove Screws and Boards. Dispose of properly. Do not use these screws to mount Spider to Table Top! Mounting Hole Hole 1. Align Mounting holes in Spider(C) with 3.
Page 3 Slot 4. Position Column(D) onto Spider while aligning slot in Column with Tab on Spider. Notch Notch Slot 5. Place Base(B) onto Column while 6. Align Anti-rotation Cap(G) with aligning Slots in Column with Notches in Base. Place into position Notches in Base.
Page 4 7. Tighten Draw Rod to 450-550 in lbs (50-62 Nm). Part no. 1b9rtx rev C. © 2013 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A. ® Y, Z, Action Office, and Mirra 2 are among the registered trademarks of Herman MIller, Inc. Sense, Setu, Be Collection and Sayl are among the trademarks of Herman Miller, Inc.