HermanMiller SS Workbar Assembly Instructions

HermanMiller
SS Workbar assembly Instructions
How to assemble SS Workbar
Tools Required
Power Driver Phillips Bit
SS Workbar
Step 1
1.1 Attach top plate to the leg, with two M8 flat head machine screws.
1.2 There are 2 ways to mount the plate to the leg :
A. Square-Out for end legs.
B. Round-Out for intermediate/shared legs.
Screw
A
HermanMiller
5 & 6 mm Safety Glass
Allen Wrench
B
Parts Included
Plate
Counter Weight
Work surface
Screen
Level
Step 2a
2a.1 Attach end legs (Left and Right) to the worksurface. This applies to both 1
piece tops and 2 piece top workbars.
2a.2 To attach the end legs follow the below procedure
A. Screw two flat head screws into these two piloted holes first to locate
the leg.
B. Finish by installing additional flat head screws in these locations.
1
#10 Pan Head #10 Flat Head
Tapping Screw Tapping Screw
Macine Screw
and Nut
End Leg
V - Cover
A
1BSSGY rev A
Flat Head Screw M10 Machine
Screw
Barrel screws Barrel screws
Intermediate Leg
Fabric Screen Slide trim
B
B
Assembly Instructions