Siemens SIMATIC ET 200L Manual page 68

ET 200L Electronics Blocks – Technical Data
Technical Data
The following table shows the technical data of the L 16 DI DC 24 V elec-
tronics block.
Dimensions and Weight
Dimensions 145
W H D (mm)
Weight Approx. 130 g
Module-Specific Data
Baud rate 9.6; 19.2; 45,45*;93.75;
187.5; 500 and
1500 kBaud
Bus protocol PROFIBUS-DP
FREEZE compatibility Yes
Number of inputs 16
Cable length
S
Unshielded Max. 600 m
S
Shielded Max. 1000 m
Manufacturer ID 0014
Voltages, Currents, Potentials
Rated supply voltage for 24 V DC
electronics (4L+, 5L+)
S
Reverse polarity Yes
protection
S
Power failure with- At least 20 ms
stand time
Rated load voltage 24 V DC
(1L+, 2L+ and 3L+)
Maximum number of in- 16
puts driven simultaneously
Galvanic isolation
S
Between channels No
S
Between channels and Yes
PROFIBUS-DP
Insulation tested with 500 V DC
Power input
S
From supply voltage Max. 70 mA
L4+/L5+
S
From load voltage L1+ Max. 50 mA per load
and L2+/L3+ (without group
load)
Power loss of module Typically 2.2 W
* If you want to run the ET 200L, ET 200L–SC or ET 200L–SC IM–SC at a transmission rate of 45.45 kbps, you
must use an updated device master file or STEP 7 as of 4.02 (K4.02.6).
8-4
60 60.5 Status display
Interrupts
Diagnostic function
S
Bus monitoring PRO-
FIBUS-DP
S
Monitoring of elec-
tronics power supply
Input voltage
S
Rated value
S
At signal "1"
S
At signal "0"
Input current
S
H
At signal "1"
Input delay
S
With "0" after "1"
S
With "1" after "0"
Input characteristic
Connection of 2-wire
BEROs
S
Permissible closed-cir-
cuit current
Status, Interrupts, Diagnostics
Green LED per channel
None
Yes
Red "BF" LED
Green "ON" LED
Sensor Selection Data
24 V DC
13 to 30 V
-30 to 5 V
Typically 5 mA at 24 V
2.0 to 4.5 ms
2.0 to 4.5 ms
To IEC 1131-2 Type 1
Possible
Max. 1.5 mA
ET 200L Distributed I/O Device
EWA-4NEB 780600902-05