Panasonic External Presentation unit 1728 Technical Description page 12

Panasonic Electric Works Fire & Security Technology Europe AB
MEW00290 Rev: 1
Push button
P1 Alarms queued
(Flera larm)
P2 Silence buzzer
Component
6
Buzzer
Display
Technical Description External Presentation unit 1728
Table of push buttons:
Colour Operation / function
Black Used, when LED "Alarms queued" (L2) is turned on,
to scroll through the queued alarms. (The first alarm
will automatically be shown again after 20 seconds,
if no button is used during that time.)
Yellow Used to silence the buzzer in the Ext. Presentation
unit. The buzzer will re-sound for an alarm from
another zone.
NOTE! Regarding "P1" and "P2", see also chapter "SW mode &
Address setting, page 11. See also ", chapter "S/W version", page 21.
Table of others:
Indicating
Interm.
Cont. + All LEDs
turned off as well.
Pre-warning, co-incidence
alarm presentation like in the c.i.e. the Ext. Presentation unit is
connected to (including a user definable text message (alarm
texts), if programmed).
One or more faults in the system will be presented as "General
fault in system".
(NOTE! A fault message may be shown, indicating a
communication fault (i.e. no connection between the unit and
the c.i.e. All LEDs are turned off as well.).
NOTE! Regarding the Display, see also chapter "SW mode &
Address setting, page 11.
5
When point alarm presentation is valid (set via Win512) the buzzer will re-
sound for an alarm from another alarm point.
6
The buzzer may be programmed as "disabled" (via Win512 / Win128), i.e.
it will not sound.
5
Fire alarm, pre-warning and co-incidence
like in the c.i.e.
There is a CPU / memory fault in the unit.
2
, Fire alarm and Heavy smoke / heat
10
2
,