Wiring Diagram - Makita DLM431 Manual

6

Wiring diagram

Route the lead wires of
Controller as shown in the
figure.
Strain relief
Route the lead wires of Power
supply cord through Line filters
C (if used), and set the Line
filters in the position shown
below.
Rib A
Put the lead wires
of Power supply
cord in this
groove.
Route the lead wires
(yellow, blue,
orange) of Power
supply cord
between the rib A
and Lead unit.
Put the lead wires into any
of these Lead wire holders.
Fig. 6-1
Power supply cord
Put the lead wires
(yellow, blue, orange)
of Power supply cord
into any of these Lead
wire holders.
Rib C
Lead unit
Rib B
Put each closed end splice into the rib B.
18 / 21
Set the sheath of Power supply cord inside A as
shown below.
Face the longer part of lead wires of Power supply
cord to Deck.
Strain relief
3mm
Do not put lead wires on the rib E and Lead unit.
Put the lead wires into
any of these Lead wire
holders.
Rib E
Rib D
A
10mm
Put each closed end splice
(2-SD) into the rib C.
Put the lead wires from
Terminal into this lead wire
holder.
Put the lead wires in this
Lead wire holder.
Put Closed end splice for
Controller lead wire
(red) and lead wires of
Lead unit in the rib D.
Deck
Controller