Makita DLM431 Manual page 13

4-5 Connecting rod, Front shaft, Rear shaft
4-5-1 Disassembling
[1] Remove the assembled part of Lower pipe and Upper pipe complete. (4-1-1 Disassembling)
[2] Remove Cowling. (4-2-1 Disassembling)
[3] Remove the assembled part of Change lever and Adjust plate. (4-3-1 Disassembling)
[4] Remove Front wheel and Rear wheel. (4-4-1 Disassembling)
[5] Loosen two 4x18 Tapping screws, and remove Protective shield. (For Canada only)
4x18 Tapping screw
(2 pcs.)
[6] Loosen two M5-8 Hex lock nuts and two Flat washers 5, and remove Connecting rod.
Fig. 4-5-1-1
Protective shield
Fig. 4-5-1-2
Connecting rod
M5-8 Hex lock nut
(2 pcs.) and
two Flat washer 5 (2 pcs.)
13 / 21