Makita DLM431 Manual page 19

Pass Lead wires (blue and red) of Motor through Line filter
B (if used), and wind it around Line filter one time, and
then put the line filter in the position shown below.
Put the lead wire
(red) of Motor
into this Lead
wire holder.
Put the lead wire
(blue) of Motor
into this Lead
wire holder.
Pass the lead
wire (blue) of
Motor through
Line filter A (if
used), and set
the line filter in
the position.
【 When Fuse unit is used 】
Put Closed end splice (5.5-SD) that the
·
lead wires of Fuse unit and Motor lead
wire (red) are crimped into the rib H.
Put the lead wires between the rib A and
·
Lead unit.
Put the lead wires in this Lead wire
holder.
Put the slack of the lead wires (blue, red) of Motor into this lead wire holder.
Fig. 6-2
Rib A
Fuse unit
19 / 21
Put the lead wire (red) of Motor and the lead wires (white,
black) into any of these Lead wire holders.
Rib H
Lead unit
Controller
Put the lead wire
(red) of Motor
into this Lead
wire holder.
Pass the lead
wire (red) of
Motor through
Line filter A (if
used), and set
the line filter in
the position.
Motor