Spare Parts/Accessories; Mcp 483C Pn; Description - Siemens SINUMERIK 828D Manual

Spare parts/accessories

11.1

MCP 483C PN

11.1.1

Description

The MCP 483C PN machine control panel enables user-friendly operation of the machine
functions. It can be used in the SINUMERIK 828D system for machine-level operation of
milling and turning machines.
All keys are designed with replaceable caps for machine-specific adaptations The key caps
can be freely inscribed using laser. Clear key caps can be used as an alternative.
The machine control panel is mounted from the rear with special tension jacks supplied with
the panel.
Operator controls
● Operating mode and function keys:
● Spindle control with override spindle (rotary switch with 16 positions)
● Feed control with override feed/rapid traverse (rotary switch with 23 positions)
● Key-operated switch (4 positions and 3 different keys)
● Emergency stop latching pushbutton, 2 contact pairs (1 NO + 1 NC)
Interfaces
● PLC I/O Interface (transfer rate: 100 MBit/s)
● 9 customer-specific inputs (e.g. for illuminated pushbuttons)
● 6 customer-specific outputs
PPU
Manual, 06/2009, 6FC5397-2DP10-0BA0
– 50 keys with assigned LEDs
– Direction keys for milling machines with rapid traverse override
(key caps for direction keys for turning machines are supplied.)
For information, refer to section: "Control and display elements" → "Front side").
NOTICE
Handwheel connections
A maximum of 2 handwheels can be connected to the SINUMERIK 828D. They must be
wired directly with terminal X143 of the PPU.
11
77