How To Spray; Choose Your Spray Tip - Graco SaniSpray HP 20 Operation - Repair - Parts

How to Spray

How to Spray
Use only water-based, non-flammable
disinfectants approved for spray
application.
Do not spray or flush with ANY
alcohol-based or other flammable liquids.
Keep spray area well-ventilated. Keep a
good supply of fresh air moving through
the area.

Choose Your Spray Tip

To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip when installing or removing the Spray
Tip and Spray Tip Guard.
Your sprayer comes with 3 Spray Tip sizes:
Fine
Medium
Coarse
Your sprayer comes from the factory with the
Medium size Spray Tip installed. Select the
appropriate Spray Tip size to provide the
acceptable spray of disinfectant. Refer to
disinfectant label for manufacturer's
recommendations.
To prevent Spray Tip leaks, make certain
Spray Tip and Spray Tip Guard are installed
properly.
1. Perform Pressure Relief Procedure,
page 8.
12
LP313
LP515
LP619
2. Use Spray Tip (A) to insert seal (B) into
Spray Tip Guard (C).
3. Insert Spray Tip into Spray Tip Guard.
Verify Spray Tip is forward in the SPRAY
position.
4. Screw Spray Tip Guard assembly onto
sprayer and hand tighten.
3A7646C