Function Setting; Indoor Unit - Fujitsu AB F18LAT Series Service Instruction

3-1. FUNCTION SETTING

3-1-1 INDOOR UNIT

Follow the instructions in the Local Setup Procedure, which is supplied with the remote control,
in accordance with the installed condition.
After the power is turned on, perform the Function Setting on the remote control.
The settings may be selected between the following two: Function Number or Setting Value.
Settings will not be changed if invalid numbers or setting values are selected.
1-1. Setting the Filter Sign (For AB / AU type)
The indoor unit has a sign to inform the user that it is time to clean the filter.
Select the time setting for the filter sign display interval in the table below according to
the amount of dust or debris in the room.
(The unit is factory set to "00")
If you do not wish the filter sign to be displayed, select the setting value for "No indication".
Setting Description
Standard
Long interval
Short interval
No indication
1-2. Setting the Ceiling Height (For AB / AU type)
Select the setting values in the table below according to the height of the ceiling.
(The unit is factory set to "00".)
Setting Description
Standard
High ceiling
The ceiling height values are fore the 4 way outlet.
Do not change this setting in the 3 way outlet mode.
(For AU type)
1-3. Setting the Static Pressure (For AR type)
Setting Description
Normal
High static pressure 1
High static pressure 2
High static pressure 3
Determine the wind volume in each mode i.e., applicable range of static pressure,
refering to TECHNICAL MANUAL.
(
Function Number Setting Value
11
(
Function Number Setting Value
20
(
Function Number Setting Value
21
03-01
Factory setting)
00
01
02
03
Factory setting)
00
01
Factory setting)
00
01
02
03