Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS (CONT.)
5. Use the remaining two socket head
shoulder screws (Hardware items "III")
to connect the two stretcher hoops to the
load cell beam assembly and securely
tighten. Make sure that the stretcher
hooks face each other in the inward
position.
6. Insert the stretcher bars into the stretcher
channel pockets on either side of the
stretcher canvas. Confirm that the
stretcher bars pass through the two
hanging loops on each side of the
stretcher canvas. Ensure that both ends
of the channel pockets are sealed, by
squeezing the Velcro strips together. The
scale is now assembled. See Powering
the Scale on page 13 for battery/AC
adapter instructions. If powering the
scale via AC adapter, see the next step
for attaching the adapter holder.
Note: The hanging loops are tethered to the
stretcher fabric. Make certain that each
stretcher bar passes through the
hanging loops. The other portion of the
hanging loop will go over the hooks of
the stretcher hoops.
7. Optional Step – For powering the
scale via AC power adapter. The AC
adapter holder can be attached to the
scale behind the display head on the
display support. Use two smaller Phillips
pan head screws (Hardware item "VIII")
to secure the adapter holder to the scale.
P/N UM2000KL_2000KG_REV20190426
12
Advertisement
Table of Contents
