Health O Meter 2000KL User Instructions page 11

ASSEMBLY INSTRUCTIONS (CONT.)
Attaching the Load Cell Beam Assembly and Stretcher Hoops
1. Hang the load cell beam assembly on
the two hooks at the end of the lifter
boom, using the loops on top of the load
cell beam assembly.
2. Connect the end of the load cell beam
cable to its port on the side of the lifter
boom.
3. Place the lock rings (Hardware items
"IV) onto the two hooks at the end of the
lifter boom, using a small flat head
screwdriver to tighten the set screws
located inside the lock ring.
4. Use the socket head shoulder screws
(Hardware items "III") to connect the
fork joint to the load cell beam assembly.
Tighten using an Allen wrench.
P/N UM2000KL_2000KG_REV20190426
11