Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS (CONT.)
Mounting the Display Head
1. Obtain the display head and align the tab
slots on the back of the display head with
the tabs on the scale display support.
2. Align the four holes on the back of the
display head with the four mounting
holes on the silver display support.
Using four of the Phillips pan head
screws (Hardware item "VII"), fasten the
display head onto the display support
using a Phillips head screwdriver to
tighten the screws.
3. Feed the load cell cable through the hole
in the display support and then up
through the mounting bracket. Plug the
load cell cable into the load cell port on
the rear of the display head.
Note: color of cable may vary.
4. Obtain the plastic bracket cover. Clip the
load cell cable into the divot in the middle
of the cover and align the cover over the
silver display support. Clip the tabs on
the cover into the display head. Obtain
two Phillips pan head screws (Hardware
item "VII") and attach the bracket cover
using a Phillips head screwdriver.
P/N UM2000KL_2000KG_REV20190426
Slots on back of display head
Slide slots onto tabs in bracket
10
Advertisement
Table of Contents
