AudioCodes Mediant 500L Hardware Installation Manual page 16

Gateway & session border controller series

Hide thumbs Also See for Mediant 500L:

Table of Contents

CHAPTER 4 Mounting the Device

Thread screws (not supplied) into each of the wall anchors. The recommended screw type is

DIN 7982 3.5x25 Phillips flat head. Make sure that the heads extend sufficiently (about 4 mm

or 0.157 in.) from the wall for the device's keyholes to hang on:

Figure 4-6:

Hold the device so that it is orientated with the bottom panel with the keyholes facing the wall

and the rear panel with the ports facing your right.

Mount the device on the wall by hanging the device's keyholes on the screw heads:

Mediant 500L Gateway & E-SBC | Hardware Installation Manual

Protruded Screw Distance from Wall Surface

Figure 4-7:

Hanging Device on Screw Heads

- 11 -

Table of Contents