Battery Hold-Down; Add Water To A Battery Without Single Point Watering System - Club Car Onward 4 Passenger Operator's Manual

2. Connect the positive (+) cable (2).
3. Connect the negative (-) cable (1).
WARNING
4. Tighten the hardware to 110 lb·in (12.4 N·m).
5. Apply battery terminal protector spray to the battery terminals.
6. Set the Run/Tow switch to RUN.

BATTERY HOLD-DOWN

Each hold-down must be tight to prevent the battery movement while the vehicle is in operation. Do
not tighten too much or the battery case can crack or buckle.
1. Tighten the hold-down nuts to 110 lb·in (12.4 N·m).
ADD WATER TO A BATTERY WITHOUT SINGLE POINT WATERING
SYSTEM
This information is for batteries without a Single Point Watering System (SPWS).
Before water is added:
• Disable the vehicle.
To add water to the batteries:
ONWARD HP NON-LIFTED 4-PASSENGER ELECTRIC
Operators Manual
TPCC01DU00EN020 (Edition A)
LOOSE BATTERY WIRES CAN CAUSE A FIRE, PROPERTY DAMAGE,
OR SERIOUS PERSONAL INJURY. MAKE SURE THAT ALL BATTERY
WIRES AND TERMINALS ARE CLEAN AND TIGHTENED
CORRECTLY.
Battery Maintenance
Battery Hold-Down
Page 75
9