Product Set Up; Product Use - Nuna mixx Manual

Product Set Up

Open Stroller
Check that you have all the parts for this product before using
it. The assembly should be performed only by adults.
1
- Separate storage latch from storage mount (1), and then lift
the handle upwards (2), a click sound means the pushchair
is open completely. Rotate the backrest to vertical position.
2
- Check that the pushchair is completely latched open
before continuing.
Assemble Canopy
1
- Align the canopy visor zipper with the zipper on the inside
of the front canopy edge. (3)
2
- Completely zip the canopy visor onto the canopy. (3)
3
- Insert the clips of canopy to the mount. (4)
Assemble Front Wheels
1
- Assemble front wheels to front legs. (5)
Check that wheels are securely attached by pulling down.
2
- To disassemble front wheel, detach front wheel from front
leg (6)-2 while pressing the release button. (6)-1
Assemble Rear Wheels
1
- Assemble brake assembly to rear legs (7), assemble rear
wheels to brake assembly (8). Wrap the connecting tube of
rear legs with the flap of the storage basket, and then snap
the three snap buttons (9).
Check that wheels are securely attached by pulling on
wheel assemblies.
11 MIXX Stroller Instructions
2
- To disassemble rear wheel, detach rear wheel from rear
wheel mount (10)-2 while pressing the release button. (10)-1
Assemble Armbar
1
- Align the armbar ends with the armbar mounts, and then
insert to lock. (11)
2
- To disassemble armbar, press armbar release button (12)-1,
and then pull out the armbar. (12)-2
3
- Attach the buttons on the both sides of the soft goods and
the seat. (13)-1
The completely assembled pushchair is shown as (13).

Product Use

Securing Child
1
- To release the buckle latch, push on center button and
remove the clips. (14)
2
- To secure child, assemble buckle. (15, 16, 17)
3
- Fit harness snugly to child by sliding each adjustment
buckle. (18)
Adjusting the Shoulder Harness Position
To adjust the position of the shoulder harness anchor, open the
zipper of seat back, turn the anchor to be level with the side
facing forward. Open the snaps, thread it through the shoulder
harness slot from back to front (19, 20). Rethread it through the
slot that is closest to child's shoulder height (21).
To avoid serious injury from falling or sliding out, always
secure your child with harness.
MIXX Stroller Instructions 12