Operation; General - Hatco DON Installation And Operating Manual

General

Edward Don Electric Conveyor Toasters are designed for ease
of operation. Perform the following procedure to operate the
toaster.
WARNING
Read all safety messages in the Important Safety
Information section before operating this equipment.
Startup
1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.
2. Move the feed ramp to the desired position.
• For automatic feeding, move the feed ramp to the
automatic feed position. Bread products enter the
toaster by placing them on the feed ramp and releasing.
• For manual feeding, rotate the feed ramp up until it rests
on top of the unit. Bread products can be loaded
manually by placing directly on the conveyor belt.
Automatic Feed
Position
Positioning the Feed Ramp
COLOR CONTROL Knob
Form No. TCDONM-0713
BURN HAzARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
3. Switch ON (I) the appropriate HEaT ON/OFF (I/O) switch
to toast bread.
4. Turn the COlOR CONTROl knob to the lightest setting
while the unit warms up. The "1" setting on the COlOR
CONTROl knob represents the lightest toast setting, and
the "7" setting represents the darkest.
NOTE: Allow approximately 15 to 20 minutes for the unit to
5. after the warm-up period, set the COlOR CONTROl knob
to the medium position and toast two slices of bread
Manual Feed
product. Then, re-adjust the COlOR CONTROl knob to
Position
the desired setting.
NOTE: To toast moist products such as English muffins, rye
Always operate toaster with crumb tray installed.
The toasting of coated or buttered products such as garlic
bread, cheese sandwiches, and sweet rolls is NOT
recommended. Residue will reduce toaster performance
and could ignite inside the toaster. Using the toaster with
the food products listed above will void unit warranty.
Shutdown
1. Switch OFF (O) the HEaT ON/OFF switches.
TOP HEAT
ON/OFF Switch
Control Panel
7
CAUTION
• To toast both sides of the bread, switch ON (I) both the
TOP HEaT ON/OFF switch and the BOTTOM HEaT
ON/OFF switch.
• To toast the top of the bread only, switch ON (I) the TOP
HEaT ON/OFF switch only.
• To toast the bottom of the bread only, switch ON (I) the
BOTTOM HEaT ON/OFF switch only.
warm up.
bread or whole wheat bread, slow the conveyor by
turning the COLOR CONTROL knob to a darker setting
(clockwise).
CAUTION
• The heating elements and the conveyor will shut off.

OPERATION

BOTTOM HEAT
ON/OFF Switch