Operation; General; Touchpad Control - Hatco ITQ Series Operating Manual

English

General

The Intelligent Toast-Qwik Conveyor Toaster is designed for
ease of operation and versatility. Use the following information
and procedures to operate the toaster.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
CAUTION
BURN HAzARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Do not remove crumb tray for cleaning until toaster is
cool.
Always operate toaster with crumb tray installed.

Touchpad Control

The following are descriptions of the controls used to operate
the Intelligent Toast-Qwik Conveyor Toaster. all controls are
located on the touchpad control at the front of the unit.
Program Keys (Keys 1–5)
Each program key stores the toast settings for a custom menu
item. Touching one of the program keys starts the
corresponding menu item toast sequence.
Standby Key
)
The Standby ( key toggles the toaster between operation
and standby. In standby, the conveyor and elements are off and
the touchpad display is dark, but the toaster remains energized.
• From standby, touch and hold the
seconds to activate the toaster. The toaster will be ready
for operation in approximately five minutes.
• From operation, touch and hold the
seconds to shut down operation and put the toaster into
standby.
POWER SAVE Key
The POWER SaVE key puts the toaster into Power Save mode.
In Power Save mode, the toaster remains activated but the heat
level drops to a reduced percentage of the current heat settings.
When restarting from Power Save mode, the unit will be ready
to toast in approximately two minutes or less.
Darker Key
The Darker ( ) key allows a single item to be toasted to a
darker shade than the current menu item setting.
To use the key:
a. Place the item on the conveyor.
b. Touch the key. This key may be touched up to five
times to produce a shade five times darker than the
current menu setting.
Form No. ITQm-0313
All manuals and user guides at all-guides.com
key for three
key for three
Lighter Key
The LIGHTER ( ) key allows a single item to be toasted to a
lighter shade than the current menu item setting.
To use the key:
a. Place the item on the conveyor.
b. Touch the key. This key may be touched up to five
times to produce a shade five times lighter than the
current menu setting.
Up/Down Arrow Keys
The Up/Down arrow (
menu items, if available. The display will show each menu item
next to its corresponding program key (1–5).
Touchpad Display
The touchpad display shows the current status of the toaster as
well as operational information related to the program keys,
chamber temperature, error messages, etc...
Touchpad Display
1 *Bun
2 Toast
3 Product 3
4 Product 4
5 Product 5
Program
Keys 1–5
Touchpad Control and Display
7

OPERATION

)
keys scroll through additional
continued...