Installation; General - Hatco DON Installation And Operating Manual

INSTALLATION

General

Use the following procedure to install an Edward Don Electric
Conveyor Toaster.
WARNING
ELECTRIC SHOCK HAzARD:
• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical receptacle.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 70°F (21°C).
FIRE HAzARD:
• Do not install unit above or around combustible surfaces.
Discoloration or combustion could occur. Unit must be
installed in non-combustible surroundings only.
• Allow a minimum clearance of 1" (25 mm) along the
sides and rear of unit. Allow a minimum clearance of
12" (305 mm) in the front. If safe distances are not
maintained, discoloration or combustion could occur.
• Do not locate toaster under shelving or closer than 12"
(305 mm) from the ceiling.
• Do not place anything on top of toaster. Do not place
toaster near or underneath curtains or other combustible
materials. Items near or on top of toaster could catch fire
causing injury and/or damage to the toaster.
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
NOTICE
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures could cause damage to the unit.
Do not locate toaster in an area that restricts air flow
around front or rear of unit. Do not locate toaster in direct
discharge path of air conditioning vent or makeup air vent.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage, complete
online warranty registration. See the IMPORTaNT
OWNER INFORMaTION section for details.
2. Remove tape and protective packaging from all surfaces
of the unit and its removable parts.
3. Place the unit in the desired location.
• locate the unit in an area where the ambient air
temperature is constant and a minimum of 85°F (29°C).
avoid areas that may be subject to active air movements
or currents (i.e., near exterior doors, exhaust fans/hoods,
air conditioning ducts, etc...).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
CAUTION
Always operate toaster with crumb tray installed.
4. level the unit by turning the
adjustable tip on each leg, if
necessary. Use a 5/8" (16 mm)
open-end wrench
leveling adjustments.
5. Install the crumb tray.
a. Position the
directly below the stop pins under the conveyor belt at
the front of the toaster.
b. Slide the crumb tray into the toaster until the front of the
crumb tray meets the stop pins.
Stop Pins
Installing the Crumb Tray
6. Install the discharge chute.
a. With the curved end facing the toaster, slide the
discharge chute underneath the toaster.
b. as the chute nears the rear of the toaster, angle the
curved end of the chute up slightly to place the rear lip
of the chute over the rear pins (one on each side).
Discharge
Chute
Installing the Discharge Chute
6
CAUTION
Shorten
to make
Lengthen
Adjustable Tip
crumb tray
Crumb Tray
Form No. TCDONM-0713
Rear
Pin