Operation; General; Operating Model Tq-10 - Hatco Toast-Qwik TQ-10 Series Installation And Operating Manual

Conveyor toasters
Hide thumbs Also See for Toast-Qwik TQ-10 Series:
Table of Contents

Advertisement

Available languages

Available languages

OPERATION

General

Toast-Qwik
Conveyor Toasters are designed for ease of
®
operation. To operate the toaster, perform the appropriate
procedure in this section.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Do not remove crumb tray for cleaning until toaster is
cool.
Always operate toaster with crumb tray installed.
Toasting of coated or buttered products such as garlic
bread, cheese sandwiches, and sweet rolls is NOT
recommended. Residue will reduce toaster performance
and could ignite inside toaster. Using toaster with food
products listed above will void unit warranty.
ColorGuard System
All TQ-400, -800, -1200, and -1800 series toasters use a
patented ColorGuard Sensing System that monitors and
automatically adjust conveyor speed during high usage
periods to assure toast color uniformity.
NOTE: The ColorGuard Sensing System is inoperable for
approximately ten minutes after any heat adjustments
are made.
CAUTION
Color Control
Control Panel – TQ-10 Series

Operating Model TQ-10

1. Plug the unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. See the
SPECIFICATIONS section for details.
2. Move the feed ramp to the desired position. Refer to
"Adjusting the Toast Feed Ramp" in this section for details.
3. Move the Top Heat (
to the I (on) position.
• For two-sided toasting, place the
the I (on) position.
• For top-sided toasting, place the
position and the
• For bottom-sided toasting, place the
(off) position and the
4. Turn the Color Control to the lowest position (
unit heats up.
NOTE: Allow approximately 15 to 20 minutes for a warm-up period.
5. After warm-up period, set the Color Control to the medium
position and toast two slices of bread product then re-
adjust the Color Control to the desired setting.
NOTE: To toast moist products such as English muffins, rye
bread, or whole wheat, slow the conveyor by turning the
Color Control knob to a darker setting (clockwise).
Bottom Heat
I/O (on/off) Switch
Top Heat
I/O (on/off) Switch
12
English
) and/or Bottom Heat (
) switches
and
switches in
switch in the I (on)
switch in the O (off) position.
switch in the O
switch in the I (on) position.
) while the
Form No. TQ2M-1219

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents