Removing The Collected Water - Nobu 20DEN1 User Manual

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
•
When the unit is off, if the bucket is full, the unit will beep 8
times and the Full indicator light will flash, the digital display
shows P2.
•
When the unit is on, if the bucket is full, the compressor turns
off and the fan turns off after 30 seconds for drying the water
of the condenser, then the unit will beep 8 times and the Full
indicator light will flash, the digital display shows P2.
•
Slowly pull out the bucket. Grip the left and right handles
securely, and carefully pull out straight so water does not spill.
Do not put the tank on the floor because the bottom of the
bucket is uneven. Otherwise the bucket will fall and cause the
water to spill.
•
Throw away the water and replace the bucket. The bucket
must be in place and securely seated for the dehumidifier to
operate.
•
The machine will re-start when the bucket is restored in its
correct position.
NOTES:
•
When you remove the bucket, do not touch any parts inside of
the unit. Doing so may damage the product.
•
Be sure to push the bucket gently all the way into the unit.
Banging the bucket against anything or failing to push it in
securely may cause the unit not to operate.
•
When you remove the bucket, if there is some water in the
unit you must dry it.
2. Continuous draining
Water can be automatically emptied into a floor drain by at-
taching the unit with a water hose (not included).
•
Cut the cover down from the back drain hose outlet. Attach
a drainhose(ID=13.5mm) and lead it to the floor drain or a
suitable drainage facility (see Fig.7).
•
Make sure the hose is secure so there are no leaks.
•
Direct the hose toward the drain, making sure that there are
no kinks that will stop the water flowing.
•
Place the end of the hose into the drain and make sure the
end of the hose is level or down to let the water flow smoothly.
Do never let it up.
•
Select the desired humidity setting and fan speed on the unit
for continuous draining to start.
NOTE: When the continuous drain feature is not being used,
remove the drain hose from the outlet.
1. Pull out the bucket a little.
2. Hold both sides of the bucket with even
strength, and pull it out from the unit.
3. Pour the water out.
Attach the
hose to the
drain hose
outlet.
9
OPERATING THE UNIT
Cut the cover down
Fig. 5
Fig. 6
Fig. 7