Advertisement
F. Your progress should look like this after mounting the first 2 heatsinks:
8 and 6 Lightbar Kit - no driver mounts yet
IMPORTANT NOTE: Never rest the LEDs down on a flat surface!! In the pics above
I have used a cup to elevate the LEDs above the towel. Resting the LEDs down
may break the monocolor (red, blue) diodes or the Input Terminals.
G. If you are building the 8 or 6 lightbar kit WITH THE UNIVERSAL DRIVER MOUNT , go
back to step " 1E "Mount the Universal Driver Mount to the Frame".
If you are not adding the Universal Driver Mount go to step H directly
below:
H. Continue sliding the heatsinks onto each end of the frame, but DO NOT tighten them
down.
a. Spacing for the 8 lightbar kit is approx 4 inches between heatsinks. Spacing for
the 6 lightbar kit is ~6.25 inches between heatsinks.
Advertisement
