Dank Light EZ-Connect DIY Grow Light Kit Assembly Instructions Manual page 22

G. Wiring the Lightstrips to the Driver
a. Previously you wired all of the Red and Black wires to your Lightstrips per either the
Meanwell Parallel OR Series Driver Wiring Instructions diagrams provided above.
Parallel Driver Wiring Instructions
a. Find the Output Section of a SINGLE driver and locate the single large Black wire with
the 2 smaller V+ and V- wires protruding from it.
b. Grab the 5 terminal Wago Solderless Connectors you previously wired to the Red (+)
wires and connect the open terminal on the Wago to the V+ Output wire from a Single
Driver.
c. Grab the 5 terminal Wago Solderless Connectors you previously wired to the Black (-)
wires from the same set of lightstrips and connect the open terminal on the Wago to
the V- Output wire from the same driver .